Hanna-instruments HI 9033 User Manual download pdf (Page 4)

INITIAL PREPARATION

Each meter is supplied complete with a 9 V battery. Remove the back

cover, unwrap the battery and install it while paying attention to its

polarity its (see "Battery Replacement" section).

Connect the probe to the meter securely by

aligning the pins with the socket, pushing

the plug in and tightening the threaded ring.

Make sure that the sleeve is properly inserted on the probe, with the

holes towards the top of the probe (i.e. the end nearest to the cable).

Make sure that the meter has been calibrated before taking any

measurements (see "Calibration" section for details).

TAKING MEASUREMENTS

To take measurement, place the probe into

the solution to be tested while making sure

that the holes are completely submerged.

Tap and stir the probe to remove any air

bubbles trapped inside the PVC sleeve.

Turn the instrument on by pressing the

ON/OFF key, and then select the desired

range by pressing the corresponding key.

If the LCD displays only a "1" on the far left

hand side, the meter is out of range and

the solution measured exceeds the selected

range. In this case, the next (higher) range

should be selected.

OPERATIONAL GUIDE

ON/OFF

FUNCTIONAL DESCRIPTION OF

HI 76302W CONDUCTIVITY PROBE

1) Watertight screened cable (1 m / 3.3')

2) 4 stainless steel rings

3) Air-release holes

4) PVC protective sleeve

1 2 3 4 5 6 7 8 9 10 11

No comments

Hanna-instruments HI 9033 User Manual Page 4